Firewor-X-tend Building instruction January 2009
7. Controlling the ailerons
Cut a hole on the
underside
of the wing with a sharp knife
app.
26-28cm from the mid of the wing
. Note not to cut
the carbon roving grid.
If the carbon disser is
behind the balsa,
hold the wing
against light
to see
it. The hole should be
slightly bigger than
the servo itself.
Shorten the lever
of
the servo, so that it
can be moved inside
the wing.
Pack the servo inside
a
shrinking tube
, so
you will be able to
remove it again.
Glue the servo
with
Stabilit Express or
with a 5minute
Epoxy.
Use a
steel wire,
d=1mm
, as pushrod.
You can make a
variable joint
by
cutting the steel and
gluing a piece of
carbon pipe on one
end.
Drill a
hole to lead
the push rod
through the wing and
glue a plastic tube for
better leading of the
push rod.
Cut
2 slits
as shown
for fixing the lever.
www.pcm.at
10
Содержание SAL-DLG FIREWOR-X-TEND
Страница 18: ......
