PINO 3.0 E Building Instruction August 2018
www.pcm.at
14
5.4 Connection of V-Tail control surfaces and carbon joiners for fuselage connection
Just set the servos and the control surfaces to
zero
and glue the
lever connectors to the pushrods
.
The black teflon should be removed before gluing.
The 6mm carbon rods should be glued into the fuselage.
If
you want more more transport comfort you could also leave
them unglued. But check the fittings before every flight. The
Fittings should be tight. If they loosen you have to make
them tight again with a drop of superglue.
5.5 Canopy
We use a very simple solution to mount the canopy.
Just
glue the carbon stick
into the canopy. Note that the gluing
spot is only
in the middle
of stick and canopy, so you can
thread the stick into the fuselage while the canopy remains on
the outer side. (here the method is shown on a glass canopy)
