page 12
In order to fasten the conditioning, the following proceedings are possible:
Spaced insertion of the sword sensor
o
Insert the sword-sensor into the stack for only approx. 10 cm, and push it
a few more centimetres into the stack every 10 seconds.
In case of a high temperature difference repeat this action – if necessary
several times!
o
If you use the sword sensor holder, please ensure that both the sword
sensor and the sword sensor holder are adjusted to the surrounding
temperature of the material.
In this case insert the sword sensor holder at frequent intervals and leave
the sword sensor in the sword sensor holder for an appropriate period.
Care instructions
Do not drop the instrument or expose it to excessive temperatures. The
instrument is not waterproof. Do not immerse the sensor in liquid.
The intervals for checking the instrument depend on your operational
demands and the required level of accuracy. In general the drift of the sensor
according to the degree of use (constant humidity or use within the
whole moisture measuring range) is beneath 0.5 % per year.
Changing the batteries
First of all remove the rubber protection cover. For that, hold the
rubber protection cover at the upper side and pull it over. If your
device
is provided with an optional USB port, you have to remove the
protection cap before. Press with your finger onto the arrow of the battery
cap and pull it back.
Remove the empty batteries. Put four new
1.5 Volt AA Alkaline batteries
in the device. Make sure that the position of the battery poles is correct.
Press down the batteries and close the cap.
Exemption from liability
For miss-readings and wrong measurements and of this resulting damage
we refuse any liability. This is a device for quick determination of moisture.
The moisture depends on multiple conditions and multiple materials.
