© PCE Instruments
5
7
Setting the Default Parameters
1.
Press and hold the CAL key for 3 seconds to enter setup menu, the tester shows current
selected number of calibration points.
2.
Press CAL key again to select 1, 2 or 3 point calibration and press ENTER key to confirm.
The tester goes to temperature unit selection mode, the display shows “
o
C/UNIT”.
3.
Press CAL key to select the temperature unit (
o
C or
o
F) and press ENTER key to confirm.
The tester goes to temperature calibration mode, the display shows “
o
C/CAL”.
4.
If you do not want to perform temperature calibration, press ENTER key, the tester goes
to the next option. If needed, press CAL key to enter the temperature calibration mode,
the display shows current temperature reading.
Enter
Enter
Cal
