10
You should see the following selections on the next screen. Click on ‘I want to add |
update | view and Echo
®
Sensors parameters’, then click on Next > at the bottom of the
screen.
Select the receiver where data from this specific sensor should be sent. This also, by
default, specifies the database where data from this sensor will be stored. The default
setting for a single receiver installation is shown below. After the receiver is selected,
click on Next >.
The software will then prompt for what system components will be changed as shown
below.
Note
: If you are setting up your actual database, it is highly recommended that you
configure the Echo
®
Sensor and update the database together. By doing this, you are
guaranteed that the sensor and database parameters will be set to the same values. Some
important program information and alarms are based on these settings. See the
Echo
®
Monitoring Software User’s Manual
for setup details.
At this time, we will focus on programming the Echo
®
Sensor only. Select ‘I will only
configure the Echo
®
device at this time’ and click Next >.
