PCB Piezotronics EX682A40, Инструкция по установке и эксплуатации

Страница: 9 / 35

SENSO
RS AN
D INS
TRUME
N
TATIO
N F
OR MAC
HINE
CON
DITION M
ONIT
ORIN
G
Connector and Pinout Diagram
The EX682 Series use plug-in type screw terminal connectors for all input and output connections
.
Strip off ~8mm of insulation from the connection wire ends. Using a small screwdriver, remove the terminal block
from the enclosure in either the up or down direction, terminate the wire in the correct location. Do not exceed a
torque of 0.5Nm. Do not leave excess uninsulated wire which can short to adjacent wiring. Re-install the terminal
block.
This easy to assemble connection method allows devices to be exchanged easily and the electrical connection to
be visibly isolated.
Pin Descriptions
:
Pin 5: Sig –
Negative Charge Input Signal
Pin 6: Shield (Common)
This pin connects shield to Pin 12.
Pin 7: Shield (Rail)
This pin connects to the Din Rail bar that the
amplifier is mounted on.
Pin 8: Sig +
Positive Charge Input Signal
Pin 9: VDC +
Attach to the positive of ICP
®
power supply
Pin 10: N/C
No Connection
Pin 11: N/C
No Connection
Pin 12: Common
Attach to the negative of ICP
®
power supply
PAGE 4