27
Chapter 3: BIOS Setup Utility
Resume On RTC Alarm
The system can be turned off with a software command. If you enable this item,
the system can automatically resume at a fixed time based on the system’s RTC
(realtime clock). Use the items below this one to set the date and time of the
wake-up alarm. You must use an ATX power supply in order to use this feature.
Resume On Ring
The system can be turned off with a software command. If you enable this item,
the system can automatically resume if there is an incoming call on the Modem.
You must use an ATX power supply in order to use this feature.
Resume On PME#
The system can be turned off with a software command. If you enable this item,
the system can automatically resume if there is an incoming call on the PCI
Modem or PCI LAN card. You must use an ATX power supply in order to use
this feature. Use this item to do wake-up action if inserting the PCI card.
Resume by WOL
This item specifies whether the system will be awakened from power saving
modes when activity or input signal of the specified WOL device is detected.
Resume On PS/2 Mouse
This item enables or disables you to allow mouse activity to awaken the system
from power saving mode.
Resume by PCI-E PME
This item specifies whether the system will be awakened from power saving
modes when activity or input signal of the specified WOL device is detected.
PWRON After PWR-Fail
This item enables your computer to automatically restart or return to its last
operating status.
Soft-Off By PWR- BTTN
If the item is set to Instant-Off, then the power button causes a software power
down. If the item is set to Delay 4 Sec. then you have to hold the power button
down for four seconds to cause power down.
USB Device Wakeup Function
This item allows you to enable or disable the USB device Wakeup function.
Resume On KBC
This item enables or disables you to allow keyboard activity to awaken the
system.
•
Wake-Up key
: When Keyboard Power On is set to Enable, this item is
available and users can enter any key, or hot key on the keyboard or
type in the password.
Press <Esc> to return to the main menu setting page.
