7
PAX-100 User Manual
Manuel d’utilisateur
PAX-100
Simply pull on the plastic barrel with a pair of small plyers to remove it from the nozzle.
Soak the components in warm soapy water, then reassemble and blow out with compressed air. When
reassembling the nozzle, ensure all the components are put back together correctly. Reinsert the plastic barrel
into the casing and firmly press the two parts together with your fingers. You will hear a faint clicking sound
when the part is in place.
Troubleshooting
Problem
Possible Cause
Solution
Unit has trouble
priming/does not spray
when tank is full.
1. Tank filter is clogged.
Remove the filter from the end of the tube inside
the tank. Reinstall the tank and try again. If
successful, gently remove the stainless steel mesh,
clean the filter and the filter body.
2. Nozzle clogged.
Follow the steps above to clean the nozzle.
Unit sprays improperly.
Debris in the nozzle.
Follow the steps above to clean the nozzle.
Spray is weak / spitting.
Solution is too thick.
The solution must have the same thickness as
water. If it resembles more like liquid soap, empty
the tank, and clean it properly. Fill with water to
clean the insides and try again.
Unit suddenly stops
spraying, or spray
weakens when in use.
Not enough solution in
the tank.
When the tank is running low on solution, it is
possible that air bubbles get sucked into the pump.
Fill the tank to prevent this from happening.
Unit is not charging.
Defective charger.
Plug the charger in the wall while leaving the other
end unplugged. The light on the charging block
must be green. Plug the other end in the unit, the
light must turn red. If it does not, the charge is
defective. Contact customer service.
Have servicing performed by a qualified repair person using only identical replacement parts. This
will ensure that the safety of the product is maintained. Contact your reseller if you need to have
the unit serviced.
