4
PAX-100 User Manual
Manuel d’utilisateur
PAX-100
Tank Manipulation Procedure
The following procedure should be done a flat surface with sufficient space to operate.
-
Your PAX-100 is shipped with the tank pre-installed. To remove it,
start by pulling the locking tab towards the front.
-
While maintaining tension on the locking tab, slightly pull the tank
towards the bottom to free it. The use of a second hand is
recommended. You may now release the locking tab.
-
You can now pull the tank forward to free it from its housing.
-
Slowly slide the tank downwards until it is free from the tube. Be
careful not to slide it down at an angle as to not damage the filter at
the tip of the tube.
-
You can now fill the tank with the included funnel. To reinstall the
tank, please follow these procedures in reverse while making sure
to follow the following instructions:
-
Start by inserting the tube in the tank as to not damage the filter at
the tip.
-
Slowly raise the tank while making sure the rear is inserted in its
housing.
-
You can now raise the front of the tank, so it sits flush with the
locking tab.
-
Pull the locking tab towards the front
-
Raise the tank towards the top
-
Release and push the locking tab towards the tank to ensure it is
properly secured.
-
You can now use your Pax-100!
