3 Product description
2020/03
993x0463x-mub-en – V02
15
Fig. 1
Mounting of the constant temperature controller
PKR6 for mixing valve with flow on the right:
1.
Turn the rotary knob of the mixing valve
into position "5".
2.
When the constant temperature controller is
delivered, it is in centre position.
By disengaging the gear (●push○), you can
adjust the controller at the rotary knob.
In this way, you can test if the actuator /
rotary knob is mounted correctly.
3.
Mount the stop bolts, if necessary.
4.
Push the constant temperature controller
PKR6 on the rotary knob of the mixing
valve and mount it onto the two stop bolts
(fig. 1).
The constant temperature controller must
be mounted according to figure 2.
5.
Re-e
ngage the gear (●push○).
6.
Set the constant temperature controller to
automatic operation mode.
7.
Connect the flow temperature sensor
(mounted in the flow ball valve) with the
constant temperature controller.
8.
After the mounting is completed, the safety
plug can be plugged into a corresponding
socket (fig. 3).
9.
For the commissioning, please observe the
instructions of the controller.
stop bolts
Fig. 2
Fig. 3
safety plug
