Paulin Model 9, Руководство пользователя

Страница: 6 / 8

MANTLE INSTALLATION & LIGHTING INSTRUCTIONS
Do not use defective mantles (holes, etc.) Replace defective mantles
immediately.
After installation and before
use have qualified gas personnel approve your
installation and check for gas leaks using a leak detector. Tubing, fittings, gas-
light valve, and any other gas transporting component should be checked. After
gaslight has been properly installed and thoroughly checked for leaks by qualified
gas personnel only:
1. Remove globe.
2. a. Pre-form mantle: Grasp ceramic ring -
do not touch mantle itself. Hook legs into
reverse “L” of the burner nose.
b. Tie-on mantle: Loop the tie-on strings at
the throat of the mantle. Work fingertips into
mantle throat and enlarge the opening so that
it will fit over the ceramic burner nose and seat
in lower groove of burner nose. Do not tie the
mantle to the Bunsen. Distribute puckers in
the mantle evenly around the burner nose.
Pull the ends of the string snugly so that
mantle and string are seated securely in
the burner nose groove. Tie a double knot
and clip off excess string.
3. Replace globe.
4. Mantle burn-off: WITH GASLIGHT VALVE HANDLE IN THE “OFF” POSITION, and in a
well ventilated room, hold a lighted match close to, but not touching, bottom of mantle. Re-
move match when mantle begins to smolder. Allow fabric to burn completely.
5. Lighting of gaslight: Light gaslight only after mantle burn-off (Step 4) has been completely
accomplished. Caution: Do not turn gaslight to “On” position until after lighting match. Do
not touch mantle with the match.
6. Turning gaslight off: To turn off, simple move gaslight valve handle to the “OFF” position.