Paul santos 570 DC, Руководство по эксплуатации, Страница: 24 / 44

20 System Functions EN
P75 Restore factory settings
• Press " " for 5 seconds
on the membrane keyboard to per-
form a complete reset.
This action will restore the original
factory settings.
0 1 0
Note:
After a complete reset of the santos a message
prompts you to re-enter the settings for "nL / HL"
(see P56) and "Li / Re" (see P57).
After a complete reset, all settings in menus P2 and
P3 and the existing controls P5 and P6 have to be
set again.
If the santos is equipped with a frost protection de-
vice it must be re-enabled in menu P51, because
following a complete reset the standard setting is
"disabled".
P76 Santos self-test 0 1 0
Note:
The santos switches to the highest level immediately when the self-
test is activated. In addition, the bypass valve also opens and closes
immediately after the self-test is activated. If this self-test is com-
pleted without malfunctions, the valve of the frost protection device
(if installed) then opens and closes.
P77 Reset dirty filter counter 0 1 0
Note:
This control command resets the counter that triggers the filter warn-
ing message. This allows the filter to be cleaned or replaced before
the filter warning message is displayed.
Menu P8
¨
Analogue control settings
Values (malfunction) information
Sub-menu Description Minimum Maximum Standard
810 Analogue input 1
0=absent 1=present 0 1 0
811 0=Open loop 1 =Closed loop
(analogue input 1) 0 1 0
812 Setpoint analogue input 1
(closed loop) 0 100 50
813 Min. setting analogue
input 1 0 99 0
814 Highest setting analogue
input 1 0 100 100
815 0=positive analogue input 1
1=negative setting analogue
input 1 0 1 0
816 Read out analogue input 1 0 100 -
820 Analogue input 2
0=absent 1=present 0 1 0
821 0=Open loop 1 =Closed loop
(analogue input 2) 0 1 0
822 Setpoint analogue input 2
(closed loop) 0 100 50