8
Adjusting the Paper Attachment for different size paper
1. The Paper Pin Bracket can be adjusted for
different paper by loosening the bolts. To avoid improper
paper feeding, the correct setting is to have the leading
edge of the paper in line with the front edge of the roller.
2. The Paper Attachment can also move for further
adjustment by loosening the set bolt and sliding the
attachment. The set collar(not shown) located on the
support shaft may need to be loosened to move the Paper
Attachment toward the mold plate.
Setting the Ring Pin Pressure Plate for your Patty Size
The Purpose of the Pressure Plate is to entrap the amount of product necessary to form your patty and to control
the firmness of your patty. With the Pressure Plate set correctly you will in turn have less leakage, oozing, over working
of your product, and less strain on your machine.
If your patty weight is 8 ounces, keep the ring pin in the storage hole as described in the picture. This will allow
the Pressure Plate to move all the way into the Hopper and stop on the welded stop. This setting traps the most product
and is the maximum volume setting.
If your patty weight is 4 ounces, place the ring pin in the 4 ounce hole.
If your patty weight is 6 ounces, place the ring pin in the 6 ounce hole.
If you would like to have a tightly packed patty, move the ring pin to a higher than recommended setting.
THESE ARE ONLY RECOMMENDED SETTINGS. A VARIETY OF CIRCUMSTANCES MAY CALL FOR YOU
TO INSERT THE RING PIN IN A DIFFERENT LOCATION.
2
1
5
6
1 - Ring Pin in storage hole
2 - 2 ounce hole
3 - 3 ounce hole
4 - 4 ounce hole
5 - 5ounce hole
6 - 6 ounce hole
7 - 7 ounce hole
8 - 8 ounce welded stop
1
8
4
7
Proper Procedure for Operating a PR12
When the Model PR12 is fully assembled with all guards secured in their proper place, put product to be molded
in the Feed Tray. Push the product through the holes in the Feed Tray Guard, or under the Feed Tray guard and into the
Hopper.
DO NOT PUT HANDS OR FINGERS, OR FOREIGN OBJECTS, SUCH AS STOMPERS OR
PLUNGERS INTO THE HOPPER. THERE ARE NO STOMPERS OR PLUNGERS NECESSARY WHEN
USING THIS UNIT, THEREFORE NONE ARE SUPPLIED.
After you allow product to drop into the Hopper turn
the machine on by moving the On/Off switch down towards the on position. The machine may need to cycle a few times
to prime the machine with product. As patties are being formed, continue to push product through the holes and under
the Feed Tray Guard. Patty paper may be added to the machine as needed. The machine can hold up to 3/4 inch of paper
at a time, but no more.
As the Mold Plate moves back and forth to form patties, a thin coating of product may accumulate over its
surface, the Knock Out Cup, or on the front of the Hopper and Transition Plate. This accumulation does occur on all
molding machines an it is nothing to be concerned with. Do Not attempt to clean this accumulation while machine is
plugged in. There are certain machine settings that may lessen this accumulation.
3
Set Bolt
Paper Pin
Bracket
Roller
Front Edge
Содержание PR12
Страница 6: ...6 4 8 9 2 3 1 7 2 10 5 11 9 12 Proper Label Location for a Model PR12 6 1 13 15 14...
Страница 24: ...24...