8
Proper Disassembly for Cleaning a
Patty-O-Matic Model PaceSetter:
Always Unplug Machine From its Power
Source Before Cleaning
- Remove Feed Tray and Mold Plate Guard
from Machine.
- Loosen the Two Hopper Bolts using
the disassembly tool provided. The two
bolts on the chamber lid may be
loosened to be able to remove the
Chamber lid for additional cleaning if
necessary.
- Remove Hopper by sliding it toward
the on/off switch and lifting it off the
Main Shaft.
- After the Hopper is removed from the
machine, remove spacer plate from the top of
the mold plate. Occasionally the spacer plate
sticks to the bottom of the Hopper.
- Remove the Mold Plate by pulling the ring
pin from the back drive and disconnecting the
Connecting Arm from the T-Knob. This will
allow the Mold Plate to be removed from
between the Guide Rails. The T-Knob may
also be unscrewed from the Back Drive, after
removing the ring pin, as an alternate means
for disassembly.
- Remove Pressure Plate by detaching
Pressure Plate Spring and sliding Pressure
Plate from inside of the Hopper. Slide
Retractable meat stop out of the hopper until
it stops. Remove feeder by loosening bolt
using the tool provided. Twist feeder washer
away from bolt and lift feeder from the inside
Feed Tray
Mold Plate
Guard
Pressure
Plate
Pressure Plate
Spring
Chamber
Lid
Feeder
Retractable
Meat Stop
Feeder
Washer
Hopper
Bolts
Speed
Driver
Chamber
Lid Bolts
Main Shaft
On/Off
Switch
Hopper
Back Drive
Ring Pin
T-Knob
Connecting
Arm
Spacer Plate
Guide Rail
8
