10
Points of Daily Lubrication For A
Patty-O-Matic Model PaceSetter:
Always Unplug Machine and use Food Approved Oil and Grease!
The Following Parts should be lubricated daily to ensure proper machine maintenance
- Pressure Foot should be lifted up
and oiled. Hold the Ball Knob
and lift up. Place a few drops of
oil on the Pressure Foot shaft and
its component parts.
- Knock Out Shaft and Bushing
should be oiled when the Knock
Out Arm is in the up position.
The picture shown displays the
Arm in the up position.
- Tower Stem should be oiled when
the Feed Tray is removed as shown.
- Rod End Bearings should be oiled
with a few drops of oil. Remember
that there are two Rod End Bearings
to be oiled. Do not allow oil to drip
on the conveyor belt.
- Main Shaft should be oiled when the
machine is disassembled as shown in
picture. Be sure to oil the bottom of the
main shaft by the Main Shaft Bushing.
- The inside of the machine can be oiled
through the Rear Inspection Opening. By
oiling here you will be lubricating some
of the inside components.
- The Grease Fitting, on the side of the
machine where the On/Off switch is
located, should be greased once every two
weeks. 3 or 4 shots of grease is
recommended.
Tower Stem
Pressure Foot
Shaft
Ball Knob
Knock Out
Shaft
Knock Out Arm
Rod End Bearings
Bushing
Main Shaft
Rear Inspection Opening
Grease Fitting Located
on this side of machine
Main Shaft
Bushing
Threaded Hole
Conveyor Belt