8
Proper Procedure for Operating a Model 330A
When the Model 330A is fully assembled with all guards secured in their proper
place, put product to be portion molded in the Feed Tray. Push the product through the
holes in the Feed Tray Guard into the Hopper opening.
DO NOT PUT HANDS OR
FINGERS, OR FOREIGN OBJESTS, SUCH AS STOMPERS OR PLUNGERS
INTO THE HOPPER. THERE ARE NO STOMPERS OR PLUNGERS NEEDED
WHEN USING THIS UNIT, THEREFORE NONE ARE SUPPLIED.
After you
allow product to drop into Hopper turn the machine on by moving the On/Off switch
down towards the on position. The machine may need to cycle a few times to prime the
machine with product. As patties are being formed continue to push product through the
holes and under the Feed Tray Guard. Patty paper may be added to the machine as
needed. The machine can hold up to 1 inch of paper at a time, but no more.
As the Mold Plate moves back and forth to form patties, a thin coating of product
may accumulate over its surface. This coating may also accumulate on the edges of the
Knock Out Cup or on the front of the Hopper and Spacer Plate. This accumulation does
occur on all molding machines. It is nothing to be concerned with. There are certain
machine settings that may lessen this accumulation.
Setting the Ring Pin Pressure Plate for your Patty Size
The Purpose of the Pressure Plate is to entrap the amount of product necessary to form
your patty. This part is also used in controlling the firmness of your patty. With the Pressure
Plate set correctly you will in turn have:
- less leakage, oozing, and coating of parts
- less kneading of your product
- and less strain on your machine.
-----------------------------------------------------------
If your patty weight is 8 ounces, keep the ring pin in the storage hole as described in the
picture. This will allow the Pressure Plate to move all the way into the Hopper and stop on the
welded stop which is the maximum volume setting.
If your patty is 4 ounces remove the ring pin from the storage hole and place it in the 4
ounce hole.
If you patty weight is to be 6 ounces, place the ring pin in the 6 ounce hole.
If you would like to have a tightly packed patty, move the ring pin to a higher than
recommended setting for that particular weight.
THESE ARE ONLY RECOMMENDED SETTINGS. A VARIETY OF CIRCUMSTANCES
MAY CALL FOR YOU TO INSERT THE RING PIN IN A DIFFERENT LOCATION.
1
2
3
4
5
6
7
8
1 - Ring Pin in storage hole
2 - 2 ounce hole
3 - 3 ounce hole
4 - 4 ounce hole
5 - 5ounce hole
6 - 6 ounce hole
7 - 7 ounce hole
8 - 8 ounce welded stop
Содержание 330A
Страница 6: ...6 Proper Label Location for a Model 330A 1 2 3 4 5 6 7 8 9 10 10 11 2 6 12...
Страница 25: ...25...