12
Points of Daily Lubrication For
Your Model 330A:
The Following Parts should be lubricated daily to ensure proper machine maintenance
- Pressure Foot should be lifted up
and oiled. Hold the Ball knob and
lift up. Place a few drops of oil
on the Pressure Foot shaft.
Always Unplug Machine and use Food Approved Oil and Grease!
- Knock Out Shaft should be oiled
when the Knock Out Arm is in the
up position. The picture shown
displays the Arm in the up
position.
- Tower Stem should be oiled when
the Feed Tray is removed as shown.
- Rod End Bearings should be oiled
with a few drops of oil. There are
two Rod End Bearings to be oiled. Do
not allow oil to drip onto the
Conveyor Belt.
Main Shaft
- Main Shaft should be oiled when the
machine is disassembled as shown in this
picture. Be sure to oil under the collar by the
machine cabinet.
- The inside of the machine can be oiled
through the Rear Inspection Opening. By
spraying oil here you will be oiling the inside
components.
- The Grease Fitting in the back of the machine
should be greased once every two weeks. 3 to
4 shots of grease are recommended.
Tower Stem
Pressure
Foot shaft
Knock Out Shaft
Ball Knob
Knock Out
Arm
Rod End
Bearings
Conveyor
Belt
Rear Inspection
Opening
Grease
Fitting
Содержание 330A
Страница 6: ...6 Proper Label Location for a Model 330A 1 2 3 4 5 6 7 8 9 10 10 11 2 6 12...
Страница 25: ...25...