Patton SmartLink 4020, Руководство пользователя

Страница: 68 / 97

Localization 68
SmartLink 4020 User Manual 7 • System
Call Progress Tones
The dialtone, confirmation, busy, ringback and offhook warning call progress tones that are played to the
handset can be set manually or the tones will be set automatically to the country specified under
Call ID
method if the checkbox, Call Progress Tones synchronization has been selected.
To set the call progress tones manually specify:
[frequency 1]@[Energy 1]+[frequency 2]@[Energy 2]#ON([ms]),OFF([ms]),R
Where:
• Frequency 1 and frequency 2 are the frequency of the tone to be played.
• Energy 1 and energy 2 are the energy level of the tone to be played in dBm.
• ON(ms) is the duration that the tone will be played in milliseconds.
• OFF(ms) is the duration of the pause between cycles of playing the tone.
• R indicates the tone should be repeated using the ON and OFF durations specified
To specify a 350-Hz and 480-Hz tone that will be played at 15 dB for one second and then pause for 0.5 sec-
onds, you would specify:
350@-15+480@-15#ON(1000),OFF(500),R
The following example would repeat playing of a tone of 280 Hz at -8 dBm for 0.3 seconds with a pause of 0.1
second and a tone of 550 Hz for 0.8 seconds with a pause of 0.15 seconds.
280@-8+550@-20#ON(300),OFF(100),ON(800),OFF(150),R
Figure 42. Call Progress Tones section of Localization window
Dial Tone
Played when prompting the user to enter a phone number.
Prompt Tone
Played when prompting the user to enter a call forward phone number.
Confirm Tone
This should be a brief tone to notify the user that the last input value has been accepted.
Holding Tone
Indicate to the local user that the far end has placed the call on hold.