A
APPPPEEN
ND
DIIX
X
A
A
PATTON ELECTRONICS G.703 SDSL MODEM
SPECIFICATIONS
Clocking Modes:
Network (G.703)
DTE Rate:
All 64k steps from 64 to 2048 kbps
Diagnostics:
V52 compliant (511/511E) pattern generator
and detector with error injection mode.
Remote Loopback (toward DSL line) and
local loopback (toward G.703 network) con
trol by a single front panel switch
LED Status:
The following LEDs are displayed on the
front panel:
DSL Link (Green Active) - DSL Link Active
E1 Link (Green Active) - Valid
G.703/G.704 connection
LOS (Red Active) - E1 loss of framing
NS (Red Active) - No signal DSL Link
ER (Flashing Red) - CRC error during nor-
mal operation, bit error during pattern gen-
eration test
TM (Active Yellow) - Test Mode Enabled
Configuration:
Externally accessible dip switches or SNMP
managed through 1095RC
Power:
5 VDC from external desk top power supply,
90-260VAC, 50-60 Hz (Universal
Input), 10W or -48 VDC
Compliance:
FCC Part 15, CE, CTR12, CRTR13
Transmission Line:
Single Twisted Pair
Line Coding:
CAP (Carrierless Amplitude and Phase
Modulation
Line Rates (DSL line):
144, 272, 400, 528, 784, 1040, 1552, 2064,
Line Interface:
Transformer coupled, 1500 VAC isolation
mDSL Physical
Connection:
RJ-45, 2 wire, polarity insensitive pins 4
and 5
G.703/G.704 Specific
Interface:
Female Dual Coaxial 75 ohm or
Female RJ-45 120 ohm
Line rate:
2.048 Mbps
Line coding:
AMI or HDB3 (selectable) HDB3 is the default
Line Framing:
G.703 (unframed) or G.704/G.732 (framed)
Isolation:
1500 Vrms
Physical Connection:
pin 1 Rx Data +
pin 2 Rx Data -
pin 4 Tx Data -
pin 5 Tx Data -
pins 3, 6, 7, 8 no connection
A
AP
PP
PE
EN
ND
DIIX
X
B
B
PATTON ELECTRONICS MODEL 1088/K
FACTORY REPLACEMENT PARTS
AND ACCESSORIES
Patton Electronics Model #
Description
1088/K.............................G.703 mDSL Rocket (CAP)
080551 ............................120V Power Supply
080552 ............................230V Power Supply
48V-PSM.........................DC Power Supply Module
08055DCUI .....................100-240VAC (+5V ±5% reg. DC/2A)
Universal Input Adapter
0805EUR ........................European Power Cord CEE 7 (“A”)
0805UK ...........................United Kingdom Power Cord (“D”)
0805US ...........................American Power Cord (“K”)
0805AUS .........................Australia/New Zealand Power Cord (“C”)
0805DEN.........................Denmark Power Cord (“E”)
0805FR............................France/Belgium Power Cord (“F”)
0805IN.............................India Power Cord (“G”)
0805IS .............................Israel Power Cord (“H”)
0805JAP..........................Japan Power Cord (“J”)
0805SW...........................Switzerland Power Cord (“L”)
07M1088/K ......................User Manual
29
30