Connecting the SmartNode to the LAN
6
SmartNode 4900 Quick Start Guide
Connecting the SmartNode to the LAN
The 4900 Ethernet ports are auto MDX, therefore a straight-through wired cable can be used for host and
switch connections (see
figure 3
).
Figure 3. Connecting the SmartNode to the network
You can check the connection with the ping command to another host on the local LAN.
172.16.1.99(if-ip)[eth0]#ping <IP Address of the host>
Respectively from the host:
ping 172.16.1.99
Note
To ping outside your local LAN, you will need to configure the
default gateway.
You may now start to configure the SmartNode from scratch using the CLI commands, but we recommend
that you start your configuration from a template. See
“Downloading a configuration example, adapting it to
your network, and loading it onto the SmartNode”
on page 7 for further details.
For a detailed description of the CLI refer to the
SmartWare Software Configuration Guide
(SCG) available on
online at:
www.patton.com/smartnode
.
100-240V
(50-60 Hz)
1 AMP
UNIT EQUIPPED WITH DUAL SUPPLIE
S
DISCONNECT BOTH SUPPLIES
BEFORE
SERVICING
UNIT EQUIPPED WITH DUAL SUPPLIES
DISCONNECT BOTH SUPPLIES
BEFORE SERVICING
100-240V
(50-60 Hz)
1 AMP
ETH 0/0
NIC ADDRESS
00:A0:BA:00:04:10
Console
Telco Ports
50
1
Reset
Expansion
ETH 0/1
Status
Activity
LAN (ETH 0/1)
Network
interface
PC or workstation
or Telnet
LAN
Internet or
WAN (optional)
WAN
(ETH 0/0)
