![background image](http://html.mh-extra.com/html/patton-electronics/smartnode-4900/smartnode-4900_quick-start-manual_763611004.webp)
Connecting a PC, logging in, and configuring the LAN IP address
4
SmartNode 4900 Quick Start Guide
Connecting a PC, logging in, and configuring the LAN IP address
Connecting power and configuring the default IP address
Connect the SmartNode to the mains power supply using the included power supply and cable. When the
RUN
LED stops blinking and remains lit, the SmartNode is ready.
The factory default IP settings are listed in
table 1
. If these addresses do not work with your network they must
be changed. Contact your network administrator if you are not sure which IP address to use in
your installation.
Note
The DHCP server is running on the ETH 0/1 of the SN4900 Series
models. All Ethernet ports are pre-configured and active.
Connecting to a PC and logging in
1.
To access the SmartNode configuration, connect a PC equipped with an RS-232 console port to the
Con-
sole
port on the front of the SmartNode. Use the included black Ethernet cable and RJ45 to DB-9 adapter
for this purpose (Model 16F-561).
Figure 2. Connecting to the PC
2.
Open a Terminal connection to the SmartNode. Use the Terminal program included with most PC oper-
ating systems (e.g. Hyper Terminal on Windows).
Table 1. Factory default IP address and network mask configuration
Item
IP Addresss(es)
Network Mask
WAN interface Ethernet 0 (ETH 0/0)
DHCP
DHCP
LAN interface Ethernet 1 (ETH 0/1)
192.168.1.1
255.255.255.0
DHCP server address range
192.168.1.10-192.168.1.19
255.255.255.0
100-240V
(50-60 Hz)
1 AMP
UNIT EQUIPPED WITH DUAL SUPPLIES
DISCONNECT BOTH SUPPLIES
BEFORE SERVICING
UNIT EQUIPPED WITH DUAL SUPPLIES
DISCONNECT BOTH SUPPLIES
BEFORE SERVICING
100-240V
(50-60 Hz)
1 AMP
ETH 0/0
NIC ADDRESS
00:A0:BA:00:04:10
Console
Telco Ports
50
1
Reset
Expansion
ETH 0/1
Status
Activity
Console port
Laptop PC
Model 16F-561
adapter and cable