![background image](http://html1.mh-extra.com/html/patton-electronics/patton-iplink-2603/patton-iplink-2603_getting-started-manual_4094964048.webp)
WAN Serial Port Configuration
48
Models 2603, 2621, and 2635 Getting Started Guide
5 • Serial Port Configuration
Time Slot Select.
For a T1 using all 24 time slots enter 1-24, for fractional T1 enter in any format for example:
1,2,3,5; or 1-5,10-24. Any entry for timeslots above 24 will return an invalid-selection message.
Line Options:
Fractional T1
Line Code:
The 2603 uses B8Zs and AMI. B8Zs is the most widely used.
Line Build Out:
Select from 100 0dB, 100 Ohm -7.5dB, 100 Ohm -15dB, and – 22.5dB. For CSU/DSU
application use 100 0dB option, consult your T1 service provider for more information.
FDL Mode:
Options are ANSI-T1-403 and Fdl-none. Consult your T1 service provider if FDL is active on
your T1 link.
Clocking Mode:
Internal, Receive Clock (network). In most applications clocking for the 2603 will be derived
from the T1 network, set the unit for Receive Recover unless instructed otherwise by your service provider.
Idle code:
Enabled, Disabled. When enabled, the 2603 inserts idle codes (7E hex) on unused timeslots. Set this
option to ‘Disabled’ unless instructed otherwise.
Power Down:
Normal, Powered Down. When powered down, T1/E1 transceiver input and output lines will
be set to high impedance to protect the device – set unit to “Normal” for regular operation.
After all options have been selected, click on the
Con
fi
gure and Activate
button at the bottom of the screen.
Additionally, save the configuration in non-volatile memory by going to the
System Configuration > Save
menu.
This concludes the T1 interface configuration via the web browser, go to section
“WAN Service Configura-
tion”
on page 52 for instructions on router/bridge and WAN service configuration.
Configuring the IPLink Series 2603 for E1 Operation
Web Configuration.
Launch
Internet Explorer
or similar web browser, type the IP address of the 2603, enter
username
superuser
and password
superuser
. From the main page click on the
T1/E1 > Configuration
. (See
figure 25
.)
Figure 25. E1 port configuration
Содержание Patton IPLink 2603
Страница 9: ...Contents Models 2603 2621 and 2635 Getting Started Guide 9 ...
Страница 24: ...24 Chapter 2 Product Overview Chapter contents Introduction 25 Applications Overview 26 ...
Страница 40: ...40 Chapter 4 Ethernet LAN Port Chapter contents Introduction 41 LAN Connections 41 Ethernet Port 41 ...
Страница 122: ...122 Appendix C Cable Recommendations Chapter contents Ethernet Cable 123 Adapter 123 ...