Using a browser to complete Model 6511RC configuration
57
Model 6511RC User Manual
3 • Configuring the Matrix Switch for operation
ter applies. When the section trace message length is defined to be
one byte, the Matrix Switch will ignore the value of
Section Trace.
5.
For
Section Trace Msg Len,
from the drop-down menu, select the value used by the SDH network your
Matrix Switch is connected to: either 1, 16, or 64-byte trace messages.
6.
For
Section Trace J0 Byte
enter the value your connected SDH network uses for the J0 byte in the SDH
frame.
Note
J0 applies only with 1-byte
Section Trace Messages. For 16-byte and
64-byte trace messages,
the trace message string applies and the value of
J0 is ignored.
7.
For SDH
Payload Mapping,
select the payload type corresponding to the way your connected SDH net-
work maps the E1 payload into the SDH frame structure. Asynchronous E1 payload mapping is most
common, so the factory default value on the Matrix Switch is
stm1MappedAsynchE1(0).
If your connected
SDH network performs byte-synchronous E1 payload mapping, then select
stm1MappedBytesynchE1(1)
from the drop-down menu.
8.
For
Tx Payload Scramble,
if your SDH network expects to receive a scrambled payload select
SDHScram-
bleEnable(1)
from the drop-down menu, otherwise select
sdhScrambleDisable(0)
.
9.
For
Rx Payload Scramble,
if your SDH network transmits a scrambled payload select
SDHScrambleEn-
able(1)
from the drop-down menu, otherwise select
sdhScrambleDisable(0)
.
10.
For
SDH Mapping
, select the type of AU corresponding to the SDH multiplexing path you desire. To
multiplex seven TUG-2s into an AU-3, select
au3Mapper(0)
(the factory default) from the drop-down
menu. To multiplex three TUG-3s into an AU-4, select
au4Mapper(1)
.
11.
Click the
Modify
button to save your work into operating memory (volatile DRAM) and activate the new
parameter values.
Configuring the SDH path trace parameters
If you selected AU-4 mapping in the preceding procedure, the Matrix Switch will display one set of five parame-
ters pertaining to Path 1. If you selected AU-3 mapping, the Matrix Switch will display three sets of five parame-
ters each pertaining to Paths 1, 2, and 3. Do the following to define the values for the SDH path trace parameters:
1.
If path trace is
enabled
in your connected SDH network, go to step 2. Otherwise, because path trace is
disabled
, in the SDH trace parameters table (see
figure 40
), for
Path-1 Trace Monitor
, select
pathTraceDis-
able(0)
from the drop-down menu. Refer to section
“Configuring DS0 idle codes”
on page 58
.
Figure 40. SDH Path Trace parameters
