Using a browser to complete Model 6511RC configuration
47
Model 6511RC User Manual
3 • Configuring the Matrix Switch for operation
19.
Press the left-arrow cursor key until the
TOP LEVEL MANAGEMENT
window displays.
20.
Select
a
for
Home
, then press
<Enter>
.
21.
Under the
Current Status
page, type
1
(
store Config(1)
) to save the changes you have just made to the con-
figuration.
This completes the initial configuration of the Model 6511RC. The next steps in configuration will be done
using your web browser connected via Ethernet to the 6511RC.
Using a browser to complete Model 6511RC configuration
This section describes the following procedures:
•
Displaying the Matrix Switch home page (see section
“Displaying the Matrix Switch 6511RC web adminis-
tration pages”
on page 47)
•
Defining the IP default gateway (see section
“Configuring the default gateway”
on page 51)
•
Defining the system clocking parameters (see section
“Configuring the system clocking parameters”
on
page 52)
•
Defining the STM-1 Circuit parameters (see section
“Configuring the SDH circuit parameters”
on
page 54)
•
Enabling idle code generation for designated DS0 channels (see section
“Configuring DS0 idle codes”
on
page 58)
•
Defining DS0 mappings within the STM-1 link (see section
“Selecting the SDH mapping path”
on
page 60)
Displaying the Matrix Switch 6511RC web administration pages
Do the following:
1.
Connect your PC’s Ethernet connection to the Ethernet LAN.
2.
Connect the 6511RC’s Matrix Switch 10/100 Ethernet port to the Ethernet LAN.
3.
At your PC, open a web browser session. In your browser’s URL/address field type the IP address of the
Model 6511RC (for example, if the Model 6511RC’s IP address
123.124.221.10
, you would type
123.124.221.10
in the browser’s URL/address field). If you do not have an IP address in your TDAC, refer
to
“Initial configuration through the RS-232 control port”
on page 43.
4.
A login prompt will appear. In the username field type
superuser
then press
<Tab>
to move the cursor to the
Password field
. In the password field type
superuser
then press
<Enter>
.
