1
2
TABLE OF CONTENTS
Section
Page
1.0 Warranty Information .............................................................2
1.1 Radio and TV Interference
1.2. CE Notice
1.3 Service
2.0 General Information ...............................................................4
2.1 Features
2.2 Description
3.0 Configuration..........................................................................5
3.1 Front Card Configuration
3.1.1 Switch Setting - Modem A
3.1.2 Switch Setting - Modem B
3.2 Rear Card Configuration
3.2.1 Rear Card Strap Settings
4.0 Installation ...........................................................................14
4.1 The Model 1000R16 Rack Chassis
4.1.1 The Rack Power Supply
4.2 Installing the Model 1004ARC into the Chassis
4.3 RS-232 Connection
4.4 Twisted Pair Connection
4.4.1 Point-to Point Twisted Pair Connection
4.4.2 Multipoint Twisted Pair Connection
5.0 Operation .............................................................................19
5.1 LED Status Monitors
5.2 Power-Up
Appendix A - Specifications........................................................20
Appendix B - Cable Recommendations......................................21
Appendix C - Factory Replacement Parts ..................................22
Appendix D - Interface Pin Assignments ....................................23
1.0 WARRANTY INFORMATION
Patton Electronics warrants all Model 1004ARC components to
be free from defects, and will—at our option—repair or replace the
product should it fail within one year from the first date of shipment.
This warranty is limited to defects in workmanship or materials,
and does not cover customer damage, abuse or unauthorized modifi-
cation. If this product fails or does not perform as warranted, your sole
recourse shall be repair or replacement as described above. Under no
condition shall Patton Electronics be liable for any damages incurred
by the use of this product. These damages include, but are not limited
to, the following: lost profits, lost savings and incidental or consequen-
tial damages arising from the use of or inability to use this product.
Patton Electronics specifically disclaims all other warranties,
expressed or implied, and the installation or use of this product shall be
deemed an acceptance of these terms by the user.
1.1 RADIO AND TV INTERFERENCE
The Model 1004ARC generates and uses radio frequency energy,
and if not installed and used properly—that is, in strict accordance with
the manufacturer's instructions—may cause interference to radio and
television reception. The Model 1004ARC has been tested and found
to comply with the limits for a Class A computing device in accordance
with the specifications in Subpart J of Part 15 of FCC rules, which are
designed to provide reasonable protection from such interference in a
commercial installation. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If the Model 1004ARC
does cause interference to radio or television reception, which can be
determined by turning the power off or disconnecting the RS-232
interface, the user is encouraged to try to correct the interference by
one of the following measures: moving the computing equipment away
from the receiver, re-orienting the receiving antenna and/or plugging
the receiving equipment into a different AC outlet (such that the com-
puting equipment and receiver are on different branches).
In the event the user detects intermittent or continuous product mal-
function due to nearby high power transmitting radio frequency equip-
ment, the user is strongly advised to take the following steps: use only
data cables with an external outer shield bonded to a metal or metal-
ized connector; and, configure the rear card as shown in section 3.2.1
of this manual.
