Pattfield Ergo Tools PE-BT25, Оригинальное руководство пользователя

Страница: 188 / 200

GB
IV - BEFORE USE
WARNING! The product
must be fully assembled
before operation! Do not
use a product that is only partly
assembled or assembled with
damaged parts. Always use
gloves during assembly.
Disconnect the spark plug
connector from the spark plug.
Intended use
1) This petrol grass trimmer is
designated with a maximum power
output of max. 0.8kW.
2) With attached trimming guard and
fitted trimmer head the petrol grass
trimmer is intended to be used to cut
small weeds, grass or similar soft
vegetation.
3) It may not be used to work on
unusual thick, dry or wet grass, e. g.
pasture grass, or to shredder leaf.
4) For safety reasons it is essential
to read the entire instruction manual
before first operation and observe
all instructions.
5) This product is for private use
only, not for any commercial
applications. It may not be used for
any purposes other than described.
1 Assembling the U-handle tube
1) Loosen the outer pre-assembled
screws on the handle
2) Place the handle onto the shaft
from the top, secure it with the
retainer and the screws (Fig. 1).
NOTE: Pay attention to the screws
and nuts. Avoid loss.
2 Assembling shaft
1) Align the lower shaft with the
clamp so that the lock pin is
orientated to the centre hole in the
clamp.(Fig.2)
2) Press the lock pin down and
insert the lower shaft into the upper
shaft. The lock pin must engage in
the centre hole of upper shaft.
3) Secure the connection by
tightening the locking knob.(Fig.3)
3 Assembling safety guard
1) Remove the bolt and washer on
the guard.
2) Place the guard over the end of
the spindle and align the holes in the
front of the guard with the slots in
the bracket on the shaft (Fig.4).
3) Insert and secure the guard by
the bolt with washer (Fig.5).
NOTE: Local regulations might
restrict the size of the cutting
guard so that it might be
necessary to use the bigger
trimming guard for cutting too.
Ask your local authorities.
4 Installing spool assembly
1) Make sure that the guard has
been attached properly.
2) Attach the trimmer head onto the
spindle (Fig.6).
3) Secure the trimmer head with
bumper clockwise (Fig.6).