EN
129
Product overview
1
Bonnet
2
Handle
3
Base plate
4
Foam pad
5
Battery (not included)
6
On / Off switch
7
Battery release switch
Using the tool
1.
Apply the proper type and amount of pol-
ishing agent to the bonnet
1
.
2.
Place the tool on the surface so that the
complete bonnet
1
is in contact. Make
sure your surface can not slip.
3.
To switch on the tool, switch on the on /
off switch
6
. Start working, while holding
the tool firmly with both hands.
4.
Move the tool slowly over the surface in
long, sweeping criss-cross strokes.
5.
Remove the bonnet from time to time and
shake out the dried residue of polishing
agent. A bonnet with excess residue will
cause streaking.
6.
To switch off the tool, switch off the on /
off switch
6
.
Intended use
The tool is intended for waxing and polishing
of plastic, metal as well as coated surfaces.
The tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
Slide the battery
5
(not included) onto
the charger and check its LED:
Red:
Charging
Green:
Battery is fully charged
Flashing Red:
Battery is defective
Flashing Green:
Battery is too hot/ cold
2
CHARGE BATTERY
Plug the charger (not included) into a
suitable wall socket.
Caution!
Only use the battery
charger specified in technical data
to charge the battery.
1
6
3
5
2
4
7
2
1
1
