-7-
When restarting a saw in the workpiece,
center the saw blade in the kerf and
check that saw teeth are not engaged
into the material. If saw blade is binding,
it may walk up or KICKBACK from the
workpiece as the saw is restarted.
Support large panels to minimize the risk
of blade pinching and KICKBACK. Large
panels tend to sag under their own
weight. Supports must be placed under
the panel on both sides, near the line of
cut and near the edge of the panel.
(
Fig. 1
)
To minimize the risk of blade pinching
and kickback, when cutting operation requires the resting of the saw on the
workpiece, the saw should be rested on the larger portion and the smaller piece cut
off. (
Fig. 1&2
)
Do not use dull, deformed, cracked or damaged blade. Unsharpened or improperly set
blades produce narrow kerf causing excessive friction, blade binding and KICKBACK.
Keep blade sharp and clean. Gum and wood pitch hardened on blades slows saw and
increases potential for kickback. Keep blade clean by first removing it from tool, and
then cleaning it with gum and pitch remover, hot water or kerosene. Never use
gasoline.
Blade depth and bevel adjusting locking levers must be tight and secure before making
cut. If blade adjustment shifts while cutting, it may cause binding and KICKBACK.
Use extra caution when making a “Plunge Cut” into existing walls or other blind areas.
The protruding blade may cut objects
that can cause KICKBACK. For plunge cuts,
retract lower guard using Retracting
Lever.
ALWAYS hold the tool firmly with both
hands. NEVER place your hand or fingers
Содержание ACS11-185
