Page
4
of 16 HPS 848 R.2
User section (only for 848R)
H
H
P
P
A
A
9
9
7
7
4
4
-
-
T
T
H
H
E
E
R
R
E
E
M
M
O
O
T
T
E
E
-
-
C
C
O
O
N
N
T
T
R
R
O
O
L
L
O
O
P
P
E
E
R
R
A
A
T
T
I
I
O
O
N
N
(
(
O
O
P
P
T
T
I
I
O
O
N
N
A
A
L
L
F
F
O
O
R
R
H
H
P
P
S
S
8
8
4
4
8
8
R
R
O
O
N
N
L
L
Y
Y
)
)
In addition to the same functions as the original remote control, through the bi-
directional transmission, the transmitter HPA 974 has useful diagnostic and control
functions.
SOU
BUTTON 3
Arming system
The entry is confirmed by:
- 1 beep (if enabled)
- 1 blinker flash (if enabled)
- LED on the dashboard
- Lock the doors (if connected)
- Activation of electric engine immobilization
(if connected)
- Activation of modules output (windows
lifter, ultrasonic, etc.)
- Enhanced output activation (electric
windows, etc.)
Press again within 10 seconds to rule the
ultrasound and radio sensors in zone 2. The
exclusion will be confirmed by 3 beeps and 3
blinker flashes.
BUTTON 1
Disarming system
Disarming is confirmed by:
- 2 beeps (if enabled)
- 2 flashing blinker (if enabled)
- Turning off the LED on the dashboard
- Unlock the doors (if connected)
- Deactivation of electric engine
immobilization (if connected)
- Deactivate output modules (ultrasound,
etc.)
After disarming, in the case of one or more
alarm cycles, the LED will display the alarm
memory after the opening of the door until
turn on the key.
BUTTON 1+2
Exclusion zone 2 sensors
Simultaneously pressing buttons 1 and 2 (after
10 sec. of the insertion system) for excluding
the alarm signal of the programmed sensors in
zone 2.
The exclusion is confirmed by 6 beeps and 6
flashes blinkers.
BUTTON 1+3
System status
Press simultaneously and release
them. If the transmitter LED will flash
for a few seconds, the alarm is
inserted. If the alarm is off, the LED
will remain off.
The function is independent of the
distance from the vehicle and is valid
when you use the same remote
control for alarm management.
LED
While pressing any of the
radio button if the LED:
Is fixe
: means
that the transmission is
received by the system.
Blinks fast
: means that
the transmission is not
received by the system
(distance too great).
Blinks 4 times
: it
means that:
the transmitter
battery is low and it
should be replaced.
BUTTON 2+3
Shock exclusion
Pressing the buttons 2 and 3
simultaneously immediately after
arming the system, you get the
exclusion of the shock sensor
confirmed by 5 beeps (if enabled)
and 5 flashing blinkers.
BUTTON 2
Panic alarm and siren stop
- The pressure of the button 2
when the system is armed causes
an alarm cycle (and therefore the
sound) for about 30 sec.
If the system is already in alarm,
this is stopped.
- Pressing the button 2 after 10
sec. of the insertion causes the
exclusion of the siren, confirmed
by 4 beeps and 4 flashes blinkers.
