Page
13
of 16 HPS 848 R.2
Installer Section
F.16
OFF
Disable alarm arming by anti-distraction function
This setting permits to disable the auto arming function of the alarm, if the vehicle
interested is equipped with the original auto arming (by the original remote control or
974).
F.17
OFF
Shock sensor disabling with the US module (by the remote control)
This setting permits to disable also the shock sensor, when, during the system arming,
it’s excluded the ultrasonic module due
the second locking press, by the original remote
control or HPA 974.
F.18
ON
Disable Panic function by the remote control
This setting permits to disable the panic function by the remote control.
F.19
OFF
Remove the arm/disarm/warning beeps from WHITE wire and from
wireless siren
This setting permits to remove the acoustical signal when the system is
armed/disarmed, from WHITE wire and wireless siren (from LIST 35).
By default, the Beeps are enabled.
F.20
OFF
Enable the engine kill during the Anti-aggression/Anti-theft cycle
Set this function to get the engine kill during Anti-aggression and/or Anti-theft
functions. The engine kill works intermittently becomes fixed within 50 seconds.
Function available with the programming functions No. 10 and/or No. 11.
F.21
OFF
PASSIVE FUNCTION WHEN ALARM OFF
After ignition off, opening and closing the driver door the function is activated, the LED
flashes quickly and within 30 sec. the alarm will arm.
During this time, you can interrupt the function turning on the ignition or by opening
any doors. The re-closing will trigger the time again.
Warning: The function can be dependent on the type of vehicle!
F.22
Contin.
Set the output wire WHITE from continuous to pulsed
Use this setting when it’s
necessary to switch the WHITE wire output to pulsed mode.
By default, the output is continuous.
F.23
ON
Inhibit the Alarm for Jammer frequency
This setting permits to disable the alarm for the Jamming function. In this case the
alarm cannot see the radio disorders.
F.24
OFF
Inhibit the Alarm arming/disarming by the OEM remote control
This setting permits to disable the alarm arming and disarming by the OEM remote
control. The alarm can be armed only by the PATROLLINE remote control HPA 974.
F.25
Comfort
& key
SWITCH the reading PIN CODE from IGNITION KEY to BRAKE PEDAL
Used for cars that do not have mechanical ignition key.
This function allows to switch the reading pin code input (default ignition key) with the
brake pedal or the parking brake (but only with the driver door opened. CAUTION: all
the functions that use the unlock code are affected by this switching.
F.26
OFF
Disarming by the ignition key ON enabled
This setting permits to disarm the alarm system, in case of emergency, to turn ON the
ignition key. The Ignition key (+15) is detected by the CAN BUS.
This is an alternative to the emergency PIN CODE.
F.27
OFF
Immobilizer function enabled
For operation see the user section
“
SPECIAL PROTECTION FUNCTION
” on
page 5.
This setting permits to enable Immobilizer function.
F.28
ON
LOCK THE DOORS WHEN VEHICLE IS MOVING
This feature allows to lock the vehicle doors when the vehicle speed exceeds 10 km/h.
The doors will be unlocked when turned off the ignition.
F.29
DISABLED "BEACON" TRANSMISSION OF THE WIRELESS SIREN
The beacon transmission keeps the wireless siren in contact with the alarm where siren
has been learned. Removing the siren without activating this function causes an alarm
trigger. To remove the siren from the system, it is also possible to remove it from
memory using function n° 2 (siren erasing).
F.30
No function
