2020
the vehicle, in which HPS 845 (H) device is installed. In case of cracking of the garage door or camper
door, HPS 845 alarm installed into the vehicle will trigger. These sensors can be memorized in 2 safety
zones of the HPS 845 (H) alarm: maximum 24 pieces in zone 1., maximum 8 pieces in zone 2.
Difference between the two zones is that sensors memorized in zone 2. (similar to the ultrasonic) can
be disarmed temporarily with twice pushing of closing button of the remote controls.
E
E
x
x
c
c
l
l
u
u
s
s
i
i
o
o
n
n
o
o
f
f
s
s
i
i
r
r
e
e
n
n
With help of the default remote control and the PATROLLINE remote control too it is possible to be
excluded the horn or siren function.
In case of usage of default remote control:
At disarmed alarm (CDL opened), turn ON and OFF the
ignition key for 3 times and, within 30 seconds, push the default remote control to close the CDL.
At this time, the central unit will sign the attempt to break in by the flashing of the blinkers only.
On
Off
1st time
2nd time
3rd time
On
Off
On
Off
(LED off)
IGNITION KEY
control to close the doors
Push the original remote
With CDL open
within 30 seconds
In case of usage of PATROLLINE remote control:
After arming of the alarm, within the 10
seconds inhibition time, push Nr. 2 button of the PATROLLINE remote control, from this time, the
device signs the triggering only with the blinker flashing. 4 beeps and 4 blinker flashings will confirm
the exclusion.
Warning! The siren exclusion is valid for only one triggering cycle! If you switch OFF the
alarm with the default or PATROLLINE remote control, the system will be restored
automatically in original state, and for the next arming it will react with beep and acoustic
signals for every triggering causes.
A
A
u
u
t
t
o
o
m
m
a
a
t
t
i
i
c
c
r
r
e
e
a
a
r
r
m
m
i
i
n
n
g
g
If the alarm was disarmed with default remote control of the vehicle, but the doors didn’t open, within
15 seconds the CDL closes back automatically the doors, and in same time the alarm switches ON.
Warning! In those cars, in which there isn’t automatic CDL closing back function, ask the
installer to program automatic rearming function of the alarm! If it is programmed,
automatic rearming function of the alarm will operate, but the CDL will close, if the alarm
was connected for it at installation! After programming automatic rearming function of the
alarm, this function will operate with the optional PATROLLINE remote controls too
according to the above mentioned!
