38
• Service repair consists of replacing worn carbon brushes only or drive belt (contact your seller or a
qualified electrician).
Cleaning
• Clean the power tool after every use. Remove dust, shavings, splinters, etc. with a brush or
compressed air if necessary.
• Clean the power tool with a wet cloth. Do not use cleaning agents or solutions; these can corrode the
plastic parts of the power tool.
Storage
• Keep the power tool in a dry and safe place.
• When storing a lithium‐ion battery for extended periods, check the state of charge regularly. The
optimal “storage” charge level is approximately 50‐80% ‐ three green LEDs on the power indicator.
TROUBLESHOOTING
Problem
Possible cause
Solution
Motor does not run
Empty battery
Recharge the battery pack
Overload due to excessive
pressure to work
Allow the motor to cool down
by running the power tool idle
at maximum speed for 3 minute
Unsatisfactory cut
Blunt blades
Use opposite edges of blades
and re‐adjust
Vibrations are too strong
Unbalanced planing head due to
blades not adjusted properly or
loose
Check and re‐adjust blades
properly
Workpiece is not properly
supported
Secure the workpiece
(in expmple on workbench)
TECHNICAL DATA
Cordless wrench PATRIOT AH18‐82
Rated voltage
18 V
No load speed
14000/min
Planing width
82 mm
Depth of cut
0‐1 mm
Weight without battery
3,5 kgs
Weight with battery
2,9 kgs
Battery charger quick charger
Rated voltage
220–240 V, 50‐60 Hz
Charging voltage and current
18 V
3,0 A
Li‐ion battery pack PATRIOT
Nominal voltage
18 V
Capacity
3,0 Ah
Noise and vibration
The declared noise and vibration emission values have been measured in accordance with a standard
test method provided by EN 60745 and may be used for comparing one power tool with another. The
declared vibration can also be used in a preliminary assessment of exposure.
