35
Recharging the battery (see Picture B)
• Remove the battery pack (6) from the power tool by pressing the release buttons (9) and pulling it
out.
• Connect the charger (10) to power, indicator LED (11) will shine red.
• Insert the battery pack (6) into the charging cradle (10), charging process will start automatically and
the indicator LED (11) will flash green during the charging.
• When the charging is finished, the LED will shine green. Complete charging of an empty battery can
take 60 min. If recharging only partially discharged battery, the charge time is shorter.
• When the battery is fully charged, disconnect the charging station from the power
• Remove the charged battery after charging from the charging station to prevent it from losing its
capacity.
Meaning of LEDs on the charging station
RED LIGHT
GREEN LIGHT
MEANING
On
Off
Connected to the power
On
Flash
Charging
On
On
Fully charged
Flash
Flash
Check the batter
Flash
Off
Hi / low temperature
Power indicator
State of battery charge can be checked by the in‐built LED indicator (8) when the battery is inserted in
the power tool. Power indicator is activated every time the switch next to 4 LED is pressed, and goes off
after 5 seconds. Number of the green LEDs determines the actual remaining capacity:
LED indicator (
on /
off)
Battery capacity
70% ‐ 100%
40% ‐ 70%
10% ‐ 40%
0 – 10%
Warning! Before putting the power tool down wait until the blades stops completely.
Unprotected blades may come into contact with the surface, this may cause loss of
control and serious injury.
Connect the dust bag
For more efficient and cleaner work, connect the dust bag (14) to the dust bag outlet (18). Continuously
check the condition of the dust bag, and empty him regularly.
Dust extraction
To remove planing debris, it is possible to connect a suitable dust extraction machine (e.g. industrial
vacuum cleaner) to the open side of debris removal port using a suitable adaptor. Make sure the vacuum
cleaner is suitable for the worked material.
Information on the blades
The power tool is designed for using two replacement planer blades with 82 mm length. The planer
blades have two blade edges and are reversible. When both cutting edges are dull the blades must be
replaced. Planer blades may not be resharpened!
Warning! Risk of injury! When mounting the blades wear protective gloves and do not
touch the edges. The blades are very sharp.
