Page 3 of 6
221017
ASSEMBLY INSTRUCTIONS (continued)
3. Install the bulb (not included).
See relamping label at socket
area or packaging for maximum
wattage allowed.
5. Attach the dome (C) to the frame (D)
by aligning holes and inserting the
two set screws (FF) from the
frame (D) into the holes on the
dome (C), then secure them with
the two set screws (FF).
4. Remove the finial (B) from the
assembly kit, and insert the
threaded pipe of the assembly
kit from the bottom of the
dome (C) through the open hole,
then secure it with the finial (B).
Turn on the power at fuse or circuit box
6. Pull out the source wires from
the outlet box. Make wire
connections using wire
connectors (CC) as follows:
• Connect the hot wire (black
insulation) from the fixture to
the black wire from the power
source.
• Connect the neutral wire (white insulation) from the
fixture to the white wire from the power source.
• Attach the fixture ground wire (bare wire) to the
crossbar unit (AA) with the green ground screw, then
depending on local code, connect it to the house
ground wire with the wire connector (CC).
Carefully put all of the wires back into the outlet box.
7. Attach the backplate (A) of the fixture to the crossbar unit (AA) by aligning and inserting
the two fixture mounting screws from the crossbar unit (AA) into the open holes on the
backplate (A), then place the two rubber pads (EE) over the exposed fixture mounting
screws before screwing the two bolt nuts (DD) on to screws.
Note: With silicone caulk compound, caulk completely around where the backplate
meets with the wall surface to prevent water from seeping into the outlet box.
CC
AA
6
7
DD
EE
A
D
AA
3
Max.60W Type A Bulb
(not included)
5
C
D
FF
4a
B
Threaded Pipe
Rubber Pad
Metal Pad
Lock Nut
Choose a mode by sliding the slide switch. The light will turn on immediately when power is applied. Wait for 30
seconds to allow the sensor to warm up.
1. TEST MODE (daytime and nighttime operation.)
● The light will turn on when motion is detected, and stay on as long as the motion continues. The light will turn off
after 5 seconds when motion is no longer detected.
FUNCTIONS AND OPERATIONS
4
B
C
Assembly Kit
Assembly Kit
Green Ground Screw
