Page 5 of 6
221017
The following parts are available for reorder if damaged or missing. Call our toll-free at 1-800-887-6326.
Spare Parts List:
Assembly Kit
6562MM (1 SET) for 356-1294
6563MM (1 SET) for 356-1295
Crossbar Unit
X1
Mounting Screw
X2
Wire Connector
X3
Bolt Nut
X2
Rubber Pad
X2
AA
BB
CC
DD
EE
Set Screw
X2
FF
●
To clean, turn off and wipe with a damp, non-abrasive cloth.
CARE AND MAINTENANCE
TROUBLESHOOTING
Refer to following information to solve your problems.
Set the slide switch in the test mode for testing.
Night
If the light
isn’t on
SYMPTOM
DAY/NIGHT
POSSIBLE CAUSE
SOLUTION
Day
Slide switch is not set in the test
mode.
Wall switch or circuit breaker is off. Turn on wall switch or circuit breaker.
Test the light bulb on normal working light fixture.
Tighten the light bulb.
Check wire connections.
Relocate fixture away from western facing wall.
Eliminate or turn off other light source, block other
light source from shining onto sensor, or relocate
fixture.
Light bulb may be burned out.
Light bulb is loose.
Incorrect or loose wire connections.
Too much sunlight is shining onto
sensor in the early evening.
Too much light is shining onto
sensor due to another light source,
such as a street lamp or other light
fixture.
The fixture may be installed in
shaded area.
Only need to relocate fixture.
No corrective action needed.
On cloudy or overcast days, the light
may stay on longer than anticipated.
Still on the manual override mode.
Turn off the light, then turn it on after 5 seconds.
False triggering caused by a heat
source, such as a heater, dryer vent,
or heated swimming pool.
Eliminate heat source or relocate fixture.
The knob is not set in any mode.
Rotate it again to the mode you want.
Day
Night
If the light
stays on
