Patlite LS7, Инструкция по эксплуатации

Страница: 19 / 28

2
Marking holes for wiring and installation.
3
Making the installation and wiring holes.
1
Verify the signal light installation position.
. Thinner
. Alcohol
. Gasoline
. Oil
Type1 Enclosure
The following requirements are
necessary for proper installation.
. Install the signal light where
excessive
vibration is not
present.
. Install the signal light on a
sturdy surface .
. Install the signal light on a
level surface .
To ensure the waterproofing
performance of this product,
do not remove the O-ring or
the waterproof packing
.
Install the signal light in an upright
position .
The buzzer is unidirectional,
therefore it is most easily audible in
the buzzer source direction.
Position
the signal light so that the buzzer
diaphragm is facing in the desired
sound direction .
( Buzzer included specifications)
Use a soft cloth, etc., dampened
with water to wipe the main signal
light unit.
(Do not use cleaners containing
chemicals such as
thinner,
alcohol, gasoline or oil .)
CAUTION
Drill, etc.
Punch, etc.
Installation Template
( P.27)
Use the installation template located on P.27 and a punch,
etc. to mark the places to make the holes.
Use a drill, etc., to make holes for installation and wiring.
Continued on next page
. Use the following tips to check the following:
. Will it obstruct other equipment?
. Can the wiring be routed properly?
. Where is the buzzer direction facing?
( Buzzer included specifications)
B
B
19
Tip
Sound Pressure might decrease in an
environment where water is
splashing .
For use on a flat surface of a type 1
enclosure
when device is installed
as intended .
(Note) Refer to the individual Instruction manuals for
the Platform bracket and Wall-mount bracket
when installing.
General Installation
Installation
6