Step 8 Carefully and loosely insert all four Phillips
head screws and flat washers into the holes in the
top of the post and then aligning them so they go
into the heater head base. Check for proper
alignment before tightening. Tighten all four screws
securely applying equal force to all four screws as
you tighten them. Do not over-tighten.
Step 9
Attach rubber protective ring to bottom of
base.
12
3 2
WING NUTS TO SECURE REFLECTOR
.
Step 10- We’re almost finished! Tip the heater
slightly (this may require the help of another
person) and place the reflector onto the top of the
heater head aligning the three holes in the reflector
with the three bolts extending from the top of the
heater head. Place a 8 mm flat washer on each
bolt and secure reflector by putting on the three
wing nuts. Tighten securely but do not over
tighten. It’s just that easy! Re-install the propane
cylinder. Your heater is now ready to be test fired.
Please read our manual thoroughly and when
comfortable with the product and its features go to
the “Lighting Instructions Section” and safely light
your heater. We know you’ll enjoy this top quality
outdoor heater for many years to come!
FINAL STEP Be certain that all screws and all
connections are fully tightened.
PLEASE NOTE: If you have a new style propane
cylinder that senses a leak in the fuel delivery
system it may automatically reduce the flow of fuel
to the burner head at the tank. You may hear a
slight “click” this is the sound of the safety device
activating. Your tank is doing exactly what it’s
designed to do and that’s to reduce the flow of gas
if it senses a leak in the system. This is done for
your protection. Again, check for leaks with a
soapy solution if this occurs.
If your tank safety
system activates turn cylinder valve off and wait
five minutes for the safety system to reset
.
NOTE: If you do not properly tighten and engage
the hand wheel and connection device at the
regulator assembly it will NOT allow gas to flow
from the tank to the appliance. Be sure your have
a 100% safety connection. Do Not use tools to
tighten regulator hand wheel to tank valve.
Preparation for use
You will need to purchase a 20-pound TYPE I
QCC/ACME propane cylinder equipped with an
Overfill Protection Device. Your
Patio Comfort
dealer or distributor can provide you with this
safety cylinder. We highly recommend you
purchase a new 20 lb. OPD cylinder manufactured
by either Worthington Cylinder or Manchester Tank
Company. Both are U.S. producers of highly
quality propane cylinders.
Please do not try to use any other propane
cylinders with this appliance. Please do not
attempt to modify our hose assembly,
regulator, valve, ignition system or other
components. These high quality components
have been integrated in your heater to
provide you with maximum safety,
performance, and reliability.
1 3
Installation of Cylinder
After purchasing a filled propane cylinder you will
be ready to install it into your Patio Comfort
heating appliance.
a. Position the propane cylinder next to your
appliance keeping in mind that the cylinder must
be kept away from any heat or open flame and
must be stored outside. Never lay a cylinder on its
side for use or storage.
b.
When you are ready to use your heater
attach the regulator to the cylinder valve.
c.
Note: Before lighting your heater please review
thoroughly all of our safety warnings and lighting
instructions. Always check the rubber hose to be
Содержание PC-02 CAB
Страница 5: ...THIS PAGE INTENTIONALLY LEFT BLANK 5...
Страница 24: ...The Vintage Series 24...
