2
DO NOT use gasoline, kerosene, or alcohol for lighting. Never use charcoal or lighter fluid with this appliance.
DO NOT use in or on recreational vehicles or boats.
DO NOT use for commercial, this appliance is for residential use only.
DO NOT touch metal parts of the appliance until it has completely cooled (about 45 minutes) to avoid burns,
unless you are wearing protective gear (oven mitts, potholders, etc.).
DO NOT alter the appliance in any manner. Alteration of appliance and use of non-manufacturer approved
parts or accessories can directly void the warranty.
DO NOT use in the presence of gases or vapors. Keep the area clear and free from combustible materials,
gasoline, and other flammable vapors and liquids.
Clean and inspect the hose before each use. If there is evidence of abrasion, wear, cuts, or leaks, the hose
must be replaced before operating the appliance. The replacement hose assembly must be as per the
manufacturer specifications specified by the manufacturer.
Move the gas hose as far away as possible from hot surfaces.
Keep the appliance’s valve compartment, burners, and circulating air passages clean. Inspect the appliance
before each use.
Keep the ventilation openings of the cylinder enclosure free and clear from debris.
Always place your appliance on a hard and level surface far away from combustibles.
The consumption of alcohol, prescription, or non-prescription drugs may impair the operators’ ability to properly
assemble or safely operate the appliance.
WARNING
INSTRUCTIONS FOR USE
Follow the instructions carefully to avoid seriously damaging your appliance and causing injury to yourself and
property. The appliance is meant for use with
propane gas ONLY,
usually connected with a 20 lb. propane gas
cylinder (not included). Assemble the appliance as per the assembly instructions carefully.
1.
Make sure LP cylinder is OFF by turning the hand wheel clockwise until it stops. And turn the control knob
to the OFF position as well.
2.
Connect LP cylinder to the appliance(LP cylinder not included) and lock LP cylinder into the nest by the
screw as shown in
Table A.
3.
Take away the lid and evenly pour the fire glass beads into the fire pit pan as shown in
Table B.
A
B
