Pathway Connectivity
VIA 12 Manual
V3 – April 2015
3
About Pathport VIA12
Pathport® VIA12 is a 12 port + 2 Gigabit Ethernet Switch designed for live entertainment
Ethernet systems, including audio and DMX-over-Ethernet networks. This manual
covers models 6740, 6741 and 6742 running firmware of 3.7.x or higher.
The VIA12 is intended specifically for signal routing between Pathport DMX-over-
Ethernet nodes, or similar equipment, and Ethernet-aware lighting control products, such
as consoles and controllers.
The VIA12, like all Pathports, is a routing device and is not a source of the control
protocols or the data being passed. Switches only provide management control over the
data path.
Upgrades implementing further Layer 2 and Layer 3 management features will be
released on the Pathway Connectivity website from time to time. The VIA12 is easily
upgraded using Pathport Manager software, a free download.
Important: The VIA12 provides hardware support for IEEE 802.3af Power-over-
Ethernet (PoE), but does not include a built-in PoE power supply. To utilize the PoE
hardware, an external 48VDC power supply must be connected to the Speakon
connector on the rear of the switch.
Installation Instructions
Pathport VIA12 is intended for desktop use, or to be mounted in a standard 19”
equipment rack, using the rack ears included.
For model #6740 truss-mount adaptors (#9003) and wall-mount kits (#9002) are
available.
The Pathport VIA12 is intended for installation in a dry, indoor location. Operating
conditions are 0°C - 40°C; 10-90% relative humidity, non-condensing.
Warning: The AC socket outlet shall be installed near the equipment and shall be easily
accessible.
Warning: This equipment relies on building installation primary overcurrent protection.
Warning: Except for the IEC chassis plug marked for AC input, all ports on the Pathport
VIA 12 are intended for low voltage data lines only. Attaching anything other than low
voltage sources to the data ports may result in severe equipment damage, and personal
injury or death.
