Pathway Connectivity
Quattro Manual
September 2014
8
Protocol Support
Property
Explanation
Available Settings
Art-Net Rx (receive)
Set node to listen for Artnet
Enable (default)
Disable
sACN Rx (receive)
Set node to listen for sACN
Enable (default)
Disable
Shownet Rx (receive)
Set node to listen for Shownet
Enable (default)
Disable
Pathport Rx (receive)
Set node to listen for Pathport
Enable (default)
Disable
Tx Data Protocol (send)
Choose transmit protocol
Artnet
sACN
Shownet
Pathport (default)
<Back>
Utilities
Property
Explanation
Available Settings
Reboot
Power cycle the node
Factory Default
Resets patches and all
properties except the IP
settings to factory values.
Includes properties, such as
signal loss, that are set from
Pathport Manager.
Factory Default Including
Network Setup
Resets patches and all
properties including the IP
settings to factory values.
Includes properties, such as
signal loss, that are set from
Pathport Manager.
<Back>
Note Regarding ArtNet, Shownet and Subnet Mask
The ArtNet protocol is explicitly sent to a broadcast address, typically
2.255.255.255 or 10.255.255.255. The Quattro must have its subnet mask set
wide enough to include this broadcast address. When using ArtNet, a Class A
subnet mask of 255.0.0.0 is recommended to ensure DMX output.
Shownet is explicitly sent to 192.168.1.255. On a Shownet system, a
Quattro should use an IP of 192.168.1.x and a subnet mask of 255.255.255.0.
