INSTALLATION:
This is a high-resolution dual-channel recording interface for your signals
mainly focused on recording control voltages.
You can record from 1014 sec at 172Hz up to 4 sec at 44.1kHz of signal
on each channel, change the playback speed and scan through the
recorded CV.
There is a dedicated attenuverter pot for your incoming signals. When
nothing is patched to the input you can use the input pot as an offset/cv
generator and record pot movements into the module.
It´s possible to save, load your signals and settings on the SD card up to
16GB of space
There are 4 different recording modes to choose from to make more
complex signals to prepare your live performances.
INTRODUCTION:
* Disconnect your synth from the power source
* Double check polarity from the ribbon cable
* After connecting the module check again you have connected the right
way, the red line should be on the -12V
* BE CAREFUL THE PINS FROM THE BACK OF THE PCB SHOULD
NOT TOUCH ANYTHING WHILE IS POWERED
BEWARE IF YOU DON´T FOLLOW THE STEPS DESCRIBED ABOVE
DAMAGING THE MODULE, WARRANTY WILL NOT BE COVERED
Содержание EPHEMERE
Страница 1: ...channel1 EPHEMERE USER MANUAL ...
