Pass XP-32, Инструкция по эксплуатации, Страница: 7 / 10

7
The hand remote uses a multi-button direct access architecture. This remote
is designed to function with and operate several pieces of Pass Laboratories
electronics. Not all functions available on this hand remote will be applicable to
your Pass Laboratories, XP-32. The Remote operation is or should be very intuitive
in operation; we have attempted to its operation as familiar as possible. Where
applicable the remote mirrors the front panel control of the XP-32.
HAND REMOTE
POWER: Power buttion is not used with the XP-32.
MUTE: Pressing mute once will quiet the pre-amp outputs; pressing mute a second
time returns the XP-32 to the previous volume control settings
INPUT SELECTION: Pressing 1,2,3,4,5 will immediately move the input to that
input selection and the volume and balance settings remain as they were, un-altered.
TAPE: Pressing the tape button selects the tape loop and displays INPUT TAPE t
with volume at 000.
BALANCE: Pressing balance left (<) or balance right (>) will increase the level in
the right or left speaker depending upon button is pushed
VOLUME: Pressing the increase (^) button or the decrease (v) button will shift the
volume setting in both channels equally in 0.5 steps. Holding either button down
will increase or decrease the level, until such time as you either release the button or
reach the limits of the volume control.
PASS THRU: Pressing this button once selects the Pass-Thru input and displays
“PASS THRU” and swiftly ramps the volume from step 0 to step 179. As a
precaution pressing any command during this ramp up sequences, aborts the ramp
up and sets the level to 000 in both channels immediately. At this point commands
are locked and un-responsive. This locking of commands is intentional and included
to help avoid excessive and potentially dangerous play back levels. Pressing “Pass
Thru” a second time exits “pass-thru” and un-locks other command functions..
DISPLAY: There are three brightness settings on the display selectable from either
the hand remote or the front panel of the Control unit: Bright, Dim and Off. The
default setting for the display is “bright”. Pressing the display button on the hand
remote or the “mode” button on the front panel steps through the 3 possible
settings.
When “off” is selected any other control function will cause the display function to
illuminate and show the products operational status for approximately 7 seconds.