Pass XP-32, Инструкция по эксплуатации, Страница: 2 / 10

2
For your protection please read the following:
Water and moisture: Electrical devices should not be used near water ( as per
example, near a bathtub, washbasin, kitchen sink, laundry tub, wet basement
or swimming pool ). Care should be taken such that objects do not have the
opportunity to fall, and that liquid is never spilled onto or into the device enclosure
through openings.
Power Sources: An electrical device must be connected to a mains power source
in strict accordance with the supplied product owner’s manual. Please verify that
the AC mains voltage specified in the product manual matches those requirements
indicated on the unit and the AC voltage provided to your location by the power
company.
Grounding: Adequate precautions should be taken so that the grounding provisions
built into an electrical product are never defeated.
Power Cords: Pass Laboratories provides a power supply cord that meets all
legislated requirements for the market in which the product was originally sold. If
you choose to substitute an after-market product we urge you to choose one that is
fully safety rated by the necessary local authority.
Power Cord Protection: Power supply cords should be routed so that they are
not likely to be walked on, abraded, or pinched by items placed on or against them,
paying particular attention to cords where they enter plugs or exit from a device.
Never under any circumstance insert a cut or damaged power cord into a mains
power socket.
Power and Signal: Cables should never be connected / disconnected with
equipment powered up. Failure to heed this warning may damage or destroy
equipment.
Ventilation: Power-amplifiers run hot, but you should be able to place your
hands on them without discomfort. You must allow for this heat in installation,
by providing for free air circulation around the product. Electronics should not be
subjected to sources of excessive radiant heat. Excessive heat can shorten the life of
the product and may cause the electronics to self-protect and shut down.
Servicing: To reduce the risk of fire, electrical shock or other injuries, the user
should not attempt to service the device beyond that which is described in the
operating instructions. All other servicing must be referred to qualified service
personnel.