MAINTENANCE & REPAIR
This tool requires minimal lubrication. A few drops of oil weekly in the air inlet is
sufficient.
Check periodically to make sure that all screws are tight. If screws are loosening up, the
use of a medium strength adhesive sealant is recommended.
Disassembly of the tool must be done in a clean environment. Some parts can be easily
damaged if disassembled with improper tools or by inadequate methods. Maintenance
should only be performed by trained personnel. Use only genuine replacement parts.
T
O PREVENT INJURY
,
ALWAYS
DISCONNECT THE AIR SUPPLY HOSE WHEN SER
-
VICING OR DISASSEMBLING THE TOOL
.
When opening the tool for maintenance, always clean all components of dirt, grit, or
particles. Inspect the tool carefully for broken parts or excessive wear, and replace if
necessary. When ordering parts, be sure to specify the right part number, and also the tool
serial number.
A
FTER ANY MAINTENANCE TO THE TOOL
,
REMOVE ALL FASTENERS BEFORE
CONNECTING AIR AND ACTUATE THE TOOL REPEATEDLY OVER A PIECE OF WOOD
OR SUBFLOORING TO INSURE PROPER OPERATION
.
A
FTER REASSEMBLY
,
ALWAYS ACTUATE THE TOOL REPEATEDLY WITHOUT
FASTENERS AGAINST A PIECE OF WOOD OR SUBFLOOR TO INSURE PROPER
OPERATION
.
