![background image](http://html1.mh-extra.com/html/paslode/918150/918150_operating-manual_761491008.webp)
7
Battery and Charging System
Battery and charging system
Warning
CHEMICAL/EXPLOSION
HAZARD
Read ALL instructions be-
fore charging or using bat-
tery. Failure to follow ALL
instructions may result in
À
re, severe burns, or re-
lease of toxic materials.
1.
2.
Remove the battery from tool or case and insert ter-
minals down into charger. The red light will come on
indicating that the battery is charging and the green
light will go out.
3.
After charging is complete, the red light will go out
and the green light will come on, indicating that the
battery is fully charged. The charger will keep the
battery at full charge until it is removed.
4.
Unplug the charger from the 120V AC outlet.
Charging Times
First charge
(new battery)
1.5 hour
Discharged Battery
5 minutes to 1.5 hour
&KDUJLQJ'RQ·WV
1.
Do not charge battery outdoors or in temperatures
below ° (
40
° ).
2.
Do not allow metal objects to come in contact with
battery terminals.
3.
Do not puncture or attempt to open battery case or
cells.
4.
Do not store battery where it will be subjected to
temperatures above
4
° (
120
° ).
.
Do not incinerate battery.
6.
Do not use a defective battery charger, one that
over-heats and/or smokes when plugged in.
7.
Do not immerse the battery or charger in water.
Charging System Accessories:
Battery Charger - Part No. 902667
Note
Remove the charger unit from the tool case and plug
it into a 120V AC outlet. Set the charger base on a
stable surface. A green light will come on to indicate
the power is on and the charger circuit is ready.
If battery is completely discharged, the red light and
the green light may alternate back and forth for up to
20 minutes. This safety feature slowly recharges the
battery until it is ready to accept the full charging
current. If the red and green lights continue to alter-
nate after 20 minutes, replace the battery.
The Paslode Cordless 18 Gauge Straight Lithium-ion
Brad Nailer comes with a rechargeable battery and
its own charging system. This charging system is
the
only one that will work with the Paslode
lithium-ion batteries.
The
ÀUVW
step in preparing a
new tool for operation is to fully charge the battery.
New batteries are shipped partially discharged
and must be charged prior to
ÀUVW
use.
Batteries
will take 5 minutes to 1.5 hour (time will be dependant
on the amount of discharge of the battery) to
recharge.
6ft. Cord
Battery
Charger
THE PASLODE BATTERY CHARGING SYSTEM
Charging Instructions
Important Charging Notes: