®
Wireless Spectrometer
PS
-
2600
2
013-14074D
blink red. When the battery is fully charged,
the Battery Status LED shines green. The
charger circuit inside the unit turns itself off
when the unit is fully charged, so it can’t be
overcharged.
Introduction
The Wireless Spectrometer is specifically
designed for introductory spectroscopy
experiments. The Bluetooth and USB
connectivity enable its use with tablets and
computers. With this one apparatus, you can
measure intensity, absorbance, transmittance,
and fluorescence, making this a powerful and
intuitive tool for your spectroscopy needs.
Specifications
Connecting the Wireless Spectrometer to a Tablet
or Computer via Bluetooth
1.
Turn on the spectrometer, and briefly hold the
ON/OFF button on the back. After all three
status LEDs blink in sequence, release the
ON/OFF button. The Bluetooth Status LED will
blink blue.
2.
Pair /connect through Bluetooth to your
computing device. This step will depend on
your computing device and operating system.
The Bluetooth Status LED will shine blue.
3.
Start the Spectrometry software. (Refer to the
Spectrometry Software User Guide at the
PASCO web page:
www.pasco.com/spectrometer
under Resources.)
4.
If the Wireless Spectrometer is not found,
select Choose Wireless Device.
5.
In the Menu, select the Wireless Spectrometer
with the Device ID # that matches the Device
ID # on the bottom of the device.
Connecting the Wireless Spectrometer to a
Computer with a USB Cable
1.
Connect the small end of the included USB into
the USB port on the back of the Spectrometer
2.
Connect the other end of the USB cable to a
USB port on the computer, or into a USB hub
connected to the computer.
3.
Turn on the Spectrometer, and briefly press
and hold the ON/OFF button on the side. After
all three status LEDs blink in sequence,
release the ON/OFF button.
4.
The USB Status LED will shine green. (NOTE:
The Bluetooth Status LED will slowly blink
blue. The Battery Status LED may also blink to
indicate that the battery is charging through
the USB cable.)
Usage
Place the sample to be examined in a cuvette.
Fill the cuvette to the point where the top of the
sample is at least 3.0 centimeters (cm) or 1.2
inches above the bottom. Put the lid on the
cuvette and put the cuvette in the cuvette
holder of the Spectrometer.
NOTE: The cuvette has two smooth sides and
two ribbed sides. When putting the cuvette into
the Spectrometer, the smooth sides need to
be along the light path (perpendicular to the
light path). The body of the spectrometer is
made from ABS. Only use solutions in the
spectrometer to which ABS shows good
chemical resistance. Avoid letting any solution
come in contact with the spectrometer
housing.
Replacement Cuvettes
Order Model SE-8739 Cuvettes and Caps to
get 100 replacement cuvettes and lids.
There are two drain ports in the bottom of the
cuvette holder to allow for drainage if
something spills into the holder, To clean the
holder, moisten a small cotton swab with
Item
Value
Resolution:
2 to 3 nanometers (nm)
Range:
380 to 950 nm
Fluorescence Excitation
Wavelengths:
405 nm and 500 nm
Light Source:
LED boosted tungsten
