www.parweld.com
www.parweld.com
9
Description
Possible cause
Remedy
Cut is not straight
1.Tip is damaged
2. Cut direction is not
correct.
Reduce
travel speed;
ensure
correct tip
is fitted for
amperage.
Observe
correct
standoff and
direction of
cut
Power source problems
Cut quality is dependent on the selection of the correct consumable,
maintenance of equipment and proper cutting technique.
Description
possible Cause
Remedy
Interlock light
illuminates
when trigger
pressed
Air pressure is set to low Adjust air pressure
to 5Bar. Restart the
power source
Interlock light
flashes when
trigger pressed
Outer nozzle or other
consumable not installed
correctly
re-assemble front
end spares to
ensure outer nozzle
is seated fully.
Restart the power
source
Interlock light
illuminates
when trigger
pressed, and
the air flow is
intromittent
Cutting tip or electrode
not installed correctly
Short circuit in side the
torch or cable
re-install the tip and
electrode. Restart
the power source
Have it checked by
a qualified engineer
Fault light
illuminates
Machine has over
heated.
Input voltage is to high
Internal machine fault
Allow machine to
cool with fan running
Ensure input voltage
is correct
Have machine
inspected by
qualified engineer
Torch does
not start when
trigger pressed
Machine is in Set mode
Change switch to
run mode on front
panel
rOutIne MaIntenanCe
The only routine maintenance required for the power supply is a
thorough cleaning and inspection, with the frequency depending on
the usage and the operating environment.
Warning
Disconnect primary power at the source before removing the
cover. Wait at least two minutes before opening the cover to
allow the primary capacitors to discharge
.
To clean the unit, remove the screws securing the outer cover,
lift off the outer cover and use a vacuum cleaner to remove any
accumulated dirt and dust. The unit should also be wiped clean,
if necessary; with solvents that are recommended for cleaning
electrical apparatus.
Faul
t
FI
n
DI
n
G
Содержание XTP-63
Страница 1: ...Operator Manual ISSUE 1 XTP 63...
Страница 13: ...www parweld com 13...