Parweld XTM 201Di, Руководство оператора

Страница: 10 / 24

www.parweld.com
10
MIG Torch Installation (continued)
8. Press end of gun against a solid object that is electrically isolated
from the welder output and press the gun trigger for several
seconds.
9. If the wire “bird nests”, jams or breaks at the drive roll, the idle
roll pressure is too great. Back the adjustment knob out 1/2 turn,
run new wire. If the only result was drive roll slippage, loosen
the Hand nut on the central connector and pull the gun forward
about 6” (15cm) away from the power source. There should be a
slight waviness in the exposed wire. If there is not waviness, the
pressure is too low. Tighten the adjustment knob 1/4 turn, reinstall
the gun cable and repeat the above steps.
10. When triggering, the electrode and drive mechanism are
electrically “LIVE” relative to work and ground and remain “LIVE”
several seconds after the gun trigger is released.
Burn back
Inside the wire feeder cabinet is a control for burn back increasing
the value increases the burn back time so the wire stick out is less.
Soft start
The machine has a pre-set soft start system.
7.0 Setting the Machine
for MIG Welding
7.1 MIG SYN Synergic MIG Welding Allows
Simple and Rapid Setup.
Follow the screen prompts to complete the machine setup.
Example setting.