PARRY AWB3, Инструкция по эксплуатации

Страница: 13 / 21

INSTRUCTION REF: IN100
ISSUE No. 6
DATE 06.06.16
Page 13 of 21
www.parry.co.uk
FAULT DIAGNOSTICS
The appliance will not work.

Check that the power switch is turned on to the appliance and the power is
in the on position.

Replace the fuse in the moulded plug (Only applies to AWB3).
o
If there is still a problem call engineer.
All other faults will be indicated by the lamp indicator on the front of the
appliance.
Table of indications are shown below:-
LED COLOURS OPERATION / CONDITION
CYCLES THROUGH COLOURS On initial power up. (Self Diagnostics)
YELLOW Filling (Need to fill within 40 sec.)
BLUE

PURPLE

RED Heat up cycle from power up.
RED Boiler has reached operating temperature.
GREEN
Boiler needs de-scaling.
The boiler will still continue to work but unit must be
de-scaled in near future.
PURPLE
The boiler cannot get water from the supply quick
enough to achieve its full capacity

Check water supply is connected / turned on to unit.

Check that the inlet hose is not kinked or trapped.
34 Tap TAPMODELS TAPMODELS
35 Tap Handle TAPMODELS TAPMODELS
36 Tap Seal TAPMODELS TAPMODELS
37 Mains Lead MLEAD25 MLEAD25
38 Wiring Loom AWB3-2LOOM AWB6-2LOOM
39 Probe Retaining Plate + Insulation ALUMTAPE1 ALUMTAPE1
40 Water Inlet Hose 1.5m HOSE01500 HOSE01500
41 Exterior Lid
AWB
3-2
TOP
A
WB
6-2
TOP