5
Additional holes can be drilled through the rear of the unit to fix the unit to the
packer if required.
To adjust the bottom of the unit to the required depth use the screws located on
the underside of the unit as per Fig 3 below.
Once the correct height, depth level and plumb has been achieved ensure all
fixing screws are fully tightened.
FIXING THE INTEGRATED PANEL
The Tilta units are designed so panels of various type and thickness’ can be used to
integrate the unit into the cabinetry.
First remove the aluminium mesh filter from the front of the unit
Locate the two fixing lugs on either side of the curved sliders (Fig. 5) below.
The panel (A) shown below is not designed to be removed during installation. Removal
of this panel may result in damage to the retaining lugs (B). Do not remove panel (A) to
install this unit.
A
B
1
